期刊论文详细信息
Journal of Petroleum Exploration and Production Technology
An investigation on the effects of silica and copper oxide nanoparticles on rheological and fluid loss property of drilling fluids
Aryab Mazumdar1  Satyajit Chowdhury1  Dharmender Kumar Gupta1  Srawanti Medhi1 
[1] University of Petroleum and Energy Studies;
关键词: Non damaging drilling fluids;    Silica nanoparticle;    Copper oxide nanoparticle;    Rheological properties;    Fluid loss control;    Genetic algorithm optimization;   
DOI  :  10.1007/s13202-019-0721-y
来源: DOAJ
【 摘 要 】

Abstract The increase in hydrocarbon production from problematic production zones having high fluid loss and formation damage has led to the emergence of non-damaging drilling fluids (NDDF). Recently, nanotechnology has found a wide array of applications in the oil and gas industry. Most applications of nanotechnology and enhancement in properties of drilling fluids are restricted to bentonite, xanthan gum and a few oil-based mud. In this study, the effects of silica and copper oxide nanoparticles on polyamine-based NDDF and conventional bentonite-based drilling fluids (BDF) were investigated. Silica nanoparticles were prepared using sol–gel method, and copper oxide nanoparticles were synthesized using co-precipitation method. Nano-based drilling fluids were prepared by dispersing nanoparticles in concentrations of 0.5%, 0.8% and 1% by weight. Furthermore, testing of these nano-based drilling fluids was conducted by measuring specific gravity, pH, rheological properties and filtrate loss at surface temperature (room temperature) and then aging it at bottom-hole temperature (80 °C). The addition of silica and copper oxide nanoparticles to both the drilling fluids did not show much effect on pH and specific gravity. Addition of 0.5% concentration of silica nanoparticles in NDDF showed least degradation in rheological properties compared to other fluids. It showed reduction in filtrate loss by 31%. Moreover, silica nanoparticles in conjunction with BDF acted as a mud thinner showing a decrease in viscosity and yield point. On the contrary, when used with NDDFs, silica nanoparticles acted as a mud thickener. Copper oxide nanoparticles behaved as a thinner in both the drilling fluids with a highest reduction in plastic viscosity of 24% for 0.8% of copper oxide nanoparticle in BDF. Thinning properties were enhanced as the doping concentrations of copper oxide nanoparticles increased; however, the fluid loss controlling ability decreased except for 0.5% concentration by 31% and 24% when used with both the drilling fluids. Additionally, optimal Herschel–Bulkley parameters have been determined by using genetic algorithm to minimize the function of sum of squared errors between observed values and model equation.

【 授权许可】

Unknown   

  文献评价指标  
  下载次数:0次 浏览次数:0次