Prediction of Oil Recovery Factor in Stratified Reservoirs after Immiscible Water-Alternating Gas Injection Based on PSO-, GSA-, GWO-, and GA-LSSVM

Energies

Jan Inge Nygård¹  Pål Østebø Andersen²  Aizhan Kengessova² 

[1] Bouvet, 4020 Stavanger, Norway;Department of Energy Resources, Faculty of Science and Technology, University of Stavanger, 4021 Stavanger, Norway;

关键词: water-alternating-gas (WAG);    physics-informed machine learning;    least square support vector machine (LSSVM);    particle swarm optimization (PSO);    dimensionless numbers;    hysteresis;   

DOI  :  10.3390/en15020656

来源: DOAJ

【 摘 要 】

In this study, we solve the challenge of predicting oil recovery factor ($\mathrm{RF}$) in layered heterogeneous reservoirs after 1.5 pore volumes of water-, gas- or water-alternating-gas (WAG) injection. A dataset of ~2500 reservoir simulations is analyzed based on a Black Oil 2D Model with different combinations of reservoir heterogeneity, WAG hysteresis, gravity influence, mobility ratios and WAG ratios. In the first model MOD1, RF is correlated with one input (an effective WAG mobility ratio $M^{*}$). Good correlation (Pearson coefficient −0.94), but with scatter, motivated a second model MOD2 using eight input parameters: water–oil and gas–oil mobility ratios, water–oil and gas–oil gravity numbers, a reservoir heterogeneity factor, two hysteresis parameters and water fraction. The two mobility ratios exhibited the strongest correlation with RF (Pearson coefficient −0.57 for gas-oil and −0.48 for water-oil). LSSVM was applied in MOD2 and trained using different optimizers: PSO, GA, GWO and GSA. A physics-based adaptation of the dataset was proposed to properly handle the single-phase injection. A total of 70% of the data was used for training, 15% for validation and 15% for testing. GWO and PSO optimized the model equally well (R² = 0.9965 on the validation set), slightly better than GA and GSA (R² = 0.9963). The performance metrics for MOD1 in the total dataset were: RMSE = 0.050 and R² = 0.889; MOD2: RMSE = 0.0080 and R² = 0.998. WAG outperformed single-phase injection, in some cases with 0.3 units higher RF. The benefits of WAG increased with stronger hysteresis. The LSSVM model could be trained to be less dependent on hysteresis and the non-injected phase during single-phase injection.

【 授权许可】

Unknown