期刊论文详细信息
Materials
Effect of Olive-Pine Bottom Ash on Properties of Geopolymers Based on Metakaolin
Dolores Eliche-Quesada1  Pedro García-Cobo1  Eduardo Bonet-Martínez1  Eulogio Castro1  Luis Pérez-Villarejo2 
[1] Department of Chemical, Environmental and Materials Engineering Higher Polytechnic School of Jaén, University of Jaen, Campus Las Lagunillas s/n, 23071 Jaén, Spain;Department of Chemical, Environmental, and Materials Engineering, Higher Polytechnic School of Linares, University of Jaen, Campus Científico-Tecnológico, Cinturón Sur s/n, 23700 Linares (Jaén), Spain;
关键词: geopolymers;    metakaolin;    biomass bottom ash;    mechanical properties;   
DOI  :  10.3390/ma13040901
来源: DOAJ
【 摘 要 】

In this research, the feasibility of using bottom ashes generated by the combustion of biomass (olive pruning and pine pruning) as a source of aluminosilicates (OPBA) has been studied, replacing the metakaolin precursor (MK) in different proportions (0, 25, 50, 75, and 100 wt.% substitution) for the synthesis of geopolymers. As alkaline activator an 8 M NaOH solution and a Na2SiO3 have been used. The geopolymers were cured 24 h in a climatic chamber at 60 °C in a water-saturated atmosphere, subsequently demoulded and cured at room temperature for 28 days. The results indicated that the incorporation of OPBA waste, which have 19.7 wt.% of Ca, modifies the characteristics of the products formed after alkaline activation. In general terms, the incorporation of increasing amounts of calcium-rich ashes results in geopolymers with higher bulk density. The compressive strength increases with the addition of up to 50 wt.% of OPBA with respect to the control geopolymers, contributing the composition of the residue to the acquisition of better mechanical behavior. The results indicate the potential use of these OPBA waste as raw material to produce unconventional cements with 28-day curing strengths greater than 10 MPa, and thermal conductivities less than 0.35 W/mK.

【 授权许可】

Unknown   

  文献评价指标  
  下载次数:0次 浏览次数:2次