Microwave Treatment of Ultramafic Nickel Ores: Heating Behavior, Mineralogy, and Comminution Effects

Minerals

Zhenghe Xu¹  Qingxia Liu¹  ErinR. Bobicki² 

[1] Department of Chemical and Materials Engineering, University of Alberta, Edmonton, AB T6G 1H9, Canada;Department of Materials Science and Engineering, University of Toronto, Toronto, ON M5S 3E4, Canada;

关键词: mineral processing;    microwave;    permittivity;    ultramafic ores;    comminution;    mineralogy;   

DOI  :  10.3390/min8110524

来源: DOAJ

【 摘 要 】

Ultramafic nickel ores are difficult to process because they contain serpentine, an anisotropic mineral with a nonspherical morphology and multiple pH-dependent surface charges. Dehydroxylation of serpentine in ultramafic nickel ores by microwave treatment is proposed to improve the processability of these ores. Upon heating, serpentine is converted to olivine, an isotropic mineral that is benign in mineral processing circuits. The microwave heating of two ultramafic nickel ores is explored in this paper, as well as effects on mineralogy and grindability. The first ore was sourced from the Okanogan nickel deposit in Washington State, USA, while the second ore was obtained from the Vale-owned Pipe deposit located in the Thomson Nickel Belt in Manitoba, Canada. The ultramafic nickel ores were found to heat well upon exposure to microwave radiation and the heating behaviors were a function of the imaginary permittivities. The temperatures achieved during microwave treatment were sufficient to dehydroxylate serpentine, and the serpentine content in ultramafic nickel ores was reduced by 63⁻84%. The grindability of ore with consistent texture (OK ore) improved dramatically with microwave treatment, whereas the grindability of ore with inconsistent texture (Pipe ore) was found to decrease. Pentlandite liberation and specific surface area improved for both ores with microwave treatment. Ultimately, microwave pretreatment did not decrease the energy required for grinding under the conditions studied. However, energy savings may be realized when overall process improvements are considered (e.g., grinding, rheology, flotation, material handling, dewatering and tailings treatment).

【 授权许可】

Unknown