The Two-Phase Conical Swirl Atomizers: Spray Characteristics

Energies

Andżelika Krupińska¹  Sylwia Włodarczak¹  Marcin Janczarek¹  Marek Ochowiak¹  Magdalena Matuszak¹  Małgorzata Markowska¹  Tomasz Szulc² 

[1] Department of Chemical Engineering and Equipment, Poznan University of Technology, 60-965 Poznan, Poland;Industrial Institute of Agricultural Engineering, Łukasiewicz Research Network, 60-963 Poznan, Poland;

关键词: conical swirl atomizer;    construction of atomizer;    atomization;    droplet size distribution;    Sauter mean diameter;    discharge coefficient;   

DOI  :  10.3390/en13133416

来源: DOAJ

【 摘 要 】

This paper presents the results of experimental studies on two-phase conical swirl atomizers. The impact of various atomizer geometries and different operational parameters of the atomization process on the spray characteristics was investigated. The influence of the mixing chamber height H_S to diameter D_S ratio and the volumetric flow rates of liquid and gas on the discharge coefficient values, spray angle, droplet size expressed by Sauter mean diameter D₃₂, volumetric and radial distributions of droplet diameters in the spray stream were determined. The analysis of results showed that the discharge coefficient values depend on the Reynolds number for liquid and gas and the atomizer geometry. The spray angle increases as the flow rate of liquid and gas increases depending on the applied atomizer construction. The Sauter mean diameter value is correlated with the geometric dimensions of the atomizer swirl chamber. The rapid increase in D₃₂ occurs after exceeding the value H_S/D_S ≈ 3. The Sauter mean diameter also depends on the operating parameters. A central area of stream is filled with smaller sized droplets as the gas flow rate increases.

【 授权许可】

Unknown