Kinetics, thermodynamics, isotherm modeling for removal of reactive Red 35 and disperse yellow 56 dyes using batch bi-polar aluminum electrocoagulation

Alexandria Engineering Journal

Nabila M. El-Mallah¹  Manal M. El-Sadaawy²  Mohamed Khedawy³  Abeer A. Moneer³  Mohamed S.H. Ramadan³ 

[1] Corresponding author at: National Institute of Oceanography and Fisheries, NIOF, Egypt.;Chemistry Department, Faculty of Science, Alexandria University, Alexandria, Egypt;National Institute of Oceanography and Fisheries, NIOF, Egypt;

关键词: Electrocoagulation;    Dye removal;    Adsorption isotherms;    Kinetics;    Regression analysis;   

DOI  :  

来源: DOAJ

【 摘 要 】

Aluminum Electrocoagulation technique was employed for the efficiency of the removal of two anionic dyes; Reactive Red 35 and Disperse Yellow 56 in a batch bi-polar system. Optimization of different operational factors such as pH (2–11), current density (43.4 and 104.2 A/m2), initial dye concentration (10–150 mg/L), number of electrodes (3–9), and magnetic stirring speed (250–1000 rpm) were conducted experimentally. It was found that the optimum conditions which gave higher percent removal for both dyes were pHi 8, magnetic stirring speed 750 rpm, 9 Al electrodes, current density 43.4 A/m2, C○ 70, and 50 mg/L for RR35 and DY56, respectively. Pseudo-first-order kinetic model best fitted the data. Different isotherm models were applied and it was found that the Langmuir and Flory–Huggins adsorption isotherms are the most fitting. The studied thermodynamic parameters clarified that the process is spontaneous and endothermic. Energy dispersive X-ray spectroscopy, and Fourier transform infrared were the way to assure that the removal of dyes was according to the adsorption onto the insoluble aluminum hydroxide flocs. The energy consumption was found to be 15.82 and 20.02 kWh/kg for RR35 and DY56, respectively. The operating cost was 0.95 and 0.6 US$/m3 for RR35 and DY56, respectively.

【 授权许可】

Unknown