EFFECT OF THE THICKNESS OF INSULATION OF PROTECTED WIRES OF HIGH-VOLTAGE OVERHEAD TRANSMISSION LINES TO THEIR CURRENT CARRYING CAPACITY

Electrical engineering & Electromechanics

V. M. Zolotaryov¹  Y. A. Antonets¹  G. V. Bezprozvannych² 

[1] Private Joint-stock company Yuzhcable works ;National Technical University "Kharkiv Polytechnic Institute" ;

关键词: bare conductor;    protected wire;    cross-linked polyethylene insulation;    oxide insulation;    thermal resistance;    optimal insulation thickness;    heat balance;    effective heat transfer coefficient;    current carrying capacity;   

DOI  :  10.20998/2074-272X.2018.2.07

来源: DOAJ

【 摘 要 】

Introduction. The main direction of technical policy in the design, construction and technical re-equipment of transmission lines is the modernization of electrical networks and increase their energy efficiency in order to increase the throughput and reliability. Problem. Existing calculation methods do not take into account the influence of insulation thickness on the long-term current load of the wires according to the values of the maximum permissible working temperature of the conductors. Purpose. The investigation of the influence of insulation thickness of the protected wires of high-voltage electric transmission lines on their current carrying capacity. Methodology. The long operating temperature of the wire when the rated load current flows is determined based on the heat balance equation. Results. A method has been developed for determining the optimum thickness of polyethylene cross linked and oxide insulation to provide the lowest thermal resistance to the heat transfer of protected wires, the use of which allows increasing the current carrying capacity by 20 % compared to bare wires. It is shown that the internal temperature drop in cross linked polyethylene insulation is an order of magnitude smaller in comparison with the oxide insulation at identical values of the dielectric loss tangent. Originality. The calculations take into account the presence on the surface of a non-insulated aluminum conductor of a natural dense film based on aluminum oxide, which protects it from further contact with air. The capacitance of a single phase conductor with insulation is determined on the basis of the calculation of the electric field in a piecewise homogeneous medium by the method of secondary sources.

【 授权许可】

Unknown