BENCHMARK EVALUATION OF REACTIVITY EFFECTS AND REACTIVITY COEFFICIENTS IN THE MOLTEN SALT REACTOR EXPERIMENT

EPJ Web of Conferences

Fratoni Massimiliano¹  Shen Dan¹ 

[1] University of California, Berkeley Department of Nuclear Engineering;

关键词: msre;    molten salt fuel;    control rod worth;    reactivity effect;   

DOI  :  10.1051/epjconf/202124706043

来源: DOAJ

【 摘 要 】

A set of benchmarks based on the experimental data from the Molten Salt Reactor Experiment (MSRE) is being compiled as part of International Reactor Physics Experiments Evaluation Reactor Physics Experiments Evaluation Project (IRPhEP). The initial benchmark that will be available in the 2019 edition of the IRPhEP handbook covers the first zero-power criticality experiment. Follow up benchmarks are under development based on the series of control rod calibration experiments performed at the MSRE, which consisted in progressive addition of a small amount (85g) of 235U in the salt followed by the insertion of the control rods acts to compensate for the excess reactivity insertion. Multiple reactivity effects and coefficients measurements are included in the benchmark: differential worth of a control rod, reactivity equivalent of 235U addition, control rod bank worth, reactivity effect of fuel circulation, isothermal temperature coefficient and fuel temperature coefficient. An uncertainty of 2% is attributed to the reported reactivity measurements from experimenters and it was believed that the uncertainty of reactor period measurement contributed the most of the experimental uncertainty. An additional 2% uncertainty was added to all reactivity measurements to represent the uncertainty for the correction factor applied to pull all the measurements on the same uranium concentration and this uncertainty was reasonably inferred by evaluating this factor on the MSRE benchmark model. The calculated reactivity equivalent of 235U additions (0.2228±0.0014, represented as the change of reactivity over the relative change of 235U mass in loop) matches well with the experiment value (0.223±0.006). Most of other calculations, including the control rod bank worth, reactivity effects of fuel circulation and isothermal and fuel temperature coefficients fall within one standard deviation from the experimental values as well.

【 授权许可】

Unknown