Mechanical Engineering Journal | |
Microstructure dependence of abrasive wear behavior in electrodeposited nanocrystalline Ni - P alloy | |
Shigeaki KOBAYASHI1  | |
[1] Division of Mechanical Engineering, Department of Innovative Engineering, Faculty of Engineering, Ashikaga Institute of Technology; | |
关键词: nanocrystalline nickel alloy; precipitation; electrodeposition; two-body abrasive wear; wear resistance; | |
DOI : 10.1299/mej.16-00719 | |
来源: DOAJ |
【 摘 要 】
Effect of microstructure on two-body abrasive wear behavior in electrodeposited Ni -4.4 mass% P alloy was investigated to obtain a clue to development of nanocrystalline materials with high wear resistance. The as-electrodeposited nanocrystalline Ni -4.4 mass% P alloy, which was in a supersaturated solid-solution, transformed into a dual phase alloy composed of Ni and Ni3P grains as a result of the precipitation of Ni3P phase by annealing. The Hall-Petch relationship between the hardness and average grain size was maintained in the annealed dual phase alloy specimens with average grain size ranging from 50 nm to 1230 nm. The wear rate of the annealed specimens decreased with decreasing average grain size accompanied by hardening. The wear rate of the annealed specimens containing hard Ni3P grains was lower than that of the as-electrodeposited specimen with the similar hardness. Although the very fine grain size induced smooth wear grooves, the conventional grain size induced rough wear grooves with turning of Ni phase. The hardness dependence of wear resistance in Ni -4.4 mass% P alloy specimens was weaker than that obtained in the case of pure metal specimens with different hardness.
【 授权许可】
Unknown