How do the geological and geophysical signatures of permeable fractures in granitic basement evolve after long periods of natural circulation? Insights from the Rittershoffen geothermal wells (France)

Geothermal Energy

P. Patrier¹  J. F. Girard²  J. Vidal³  C. Glaas³  A. Genter³ 

[1]CNRS UMR 7285 IC2MP, HydrASA, University of Poitiers

[2]CNRS, UMR 7516 IPGS, University of Strasbourg

[3]ES Géothermie

关键词: Granite;    Fracture;    Hydrothermal alteration;    Mineralogy;    Caliper;    Resistivity;   

DOI  :  10.1186/s40517-018-0100-9

来源: DOAJ

【 摘 要 】

Abstract Two deep wells were drilled at Rittershoffen (Alsace, France) to produce high-temperature fluids to supply heat to a biorefinery. The GRT-2 production well was drilled to a depth of 3196 m MD and was deviated to target a permeable local fault in the granitic basement buried beneath a thick sedimentary cover. The objective of this study is to better understand the permeability of fractured reservoirs within crystalline rocks, focusing on the production well GRT-2. Based on a petrographic and mineralogical analysis of cutting samples, several granitic facies associated with hydrothermal alteration were identified on the basis of the amounts of illite, chlorite, anhydrite, secondary geodic quartz, and oxides. These observations were correlated with various geological and geophysical datasets (gamma ray, porosity, density, electrical resistivity, caliper, borehole image logs, temperature, rate of penetration, and mud losses) to localize and identify permeable fracture zones. In sections where acoustic image logs were not available, such as in the deepest part of the well, the geometries of the fracture zones were interpreted from an oriented caliper log. The caliper log interpretation detected one-third of the fractures detected by acoustic image logs. However, two major fracture sets striking N–S and dipping eastward or westward were observed. Furthermore, a synthetic resistivity log that fits the measured resistivity log relatively well was built using the Archie and Waxman and Smits models. This approach is a proxy for estimating the porosity and the mineralogical changes based on the cation exchange capacity, which is controlled by the chlorite/illite ratio, derived from electrical logs in granitic formations. The correlation of all these results allowed the identification of a resistivity signature of a permeable fracture zone that spatially fits with the temperature signature. The major contribution of this study is the identification of a hierarchy of permeable fractures based on petrophysical signatures. The geophysical signature of fracture zones with low residual permeability exhibits a broad depth extent, whereas the geophysical signature of a highly permeable fracture zone is more localized. Past hydrothermal circulation has enlarged the altered and porous zones around open fractures, and in some cases, intense illitization has plugged these fracture zones and reduced their permeabilities.

【 授权许可】

Unknown