Energy Use of Flux Salt Recovery Using Bipolar Membrane Electrodialysis for a CO2 Mineralisation Process

Entropy

Evelina Koivisto¹  Ron Zevenhoven¹ 

[1]Thermal and Flow Engineering Laboratory, Åbo Akademi University, Piispankatu 8, 20500 Turku, Finland

关键词: bipolar membrane electrodialysis;    ammonium sulfate;    ammonium bisulfate;    CO₂ sequestration;    mineral carbonation;   

DOI  :  10.3390/e21040395

来源: DOAJ

【 摘 要 】

Mineral carbonation routes have been extensively studied for almost two decades at Åbo Akademi University, focusing on the extraction of magnesium from magnesium silicates using ammonium sulfate (AS) and/or ammonium bisulfate (ABS) flux salt followed by carbonation. There is, however, a need for proper recovery and recirculation of chemicals involved. This study focused on the separation of AS, ABS and aqueous ammonia using different setups of bipolar membrane electrodialysis using both synthetic and rock-derived solutions. Bipolar membranes offer the possibility to split water, which in turn makes it possible to regenerate chemicals like acids and bases needed in mineral carbonation without excess gas formation. Tests were run in batch, continuous, and recirculating mode, and exergy (electricity) input during the tests was calculated. The results show that separation of ions was achieved, even if the solutions obtained were still too weak for use in the downstream process to control pH. Energy demand for separating 1 kg of NH₄⁺ varied in the range 1.7, 3.4, 302 and 340 MJ/kg NH₄⁺, depending on setup chosen. More work must hence be done in order to make the separation more efficient, such as narrowing the cell width.

【 授权许可】

Unknown