Vacuum Testing of a Miniaturized Switch Mode Amplifier Powering an Electrothermal Plasma Micro-Thruster

Frontiers in Physics

Juan Rivas-Davila¹  Wei Liang¹  Luke Raymond¹  Christine Charles²  Roderick W. Boswell² 

[1] Department of Electrical Engineering, Stanford UniversityStanford, CA, United States;Space Plasma, Power and Propulsion Laboratory, Research School of Physics and Engineering, Australian National UniversityCanberra, ACT, Australia;

关键词: thrusters;    amplifiers;    electronic;    radiofrequency plasmas;    switch mode amplifier;    nano-satellite;   

DOI  :  10.3389/fphy.2017.00036

来源: DOAJ

【 摘 要 】

A structurally supportive miniaturized low-weight (≤150 g) radiofrequency switch mode amplifier developed to power the small diameter Pocket Rocket electrothermal plasma micro-thruster called MiniPR is tested in vacuum conditions representative of space to demonstrate its suitability for use on nano-satellites such as “CubeSats.” Argon plasma characterization is carried out by measuring the optical emission signal seen through the plenum window vs. frequency (12.8–13.8 MHz) and the plenum cavity pressure increase (indicative of thrust generation from volumetric gas heating in the plasma cavity) vs. power (1–15 Watts) with the amplifier operating at atmospheric pressure and a constant flow rate of 20 sccm. Vacuum testing is subsequently performed by measuring the operational frequency range of the amplifier as a function of gas flow rate. The switch mode amplifier design is finely tuned to the input impedance of the thruster (~16 pF) to provide a power efficiency of 88% at the resonant frequency and a direct feed to a low-loss (~10 %) impedance matching network. This system provides successful plasma coupling at 1.54 Watts for all investigated flow rates (10–130 sccm) for cryogenic pumping speeds of the order of 6,000 l.s−1 and a vacuum pressure of the order of ~2 × 10−5 Torr during operation. Interestingly, the frequency bandwidth for which a plasma can be coupled increases from 0.04 to 0.4 MHz when the gas flow rate is increased, probably as a result of changes in the plasma impedance.

【 授权许可】

Unknown