期刊论文详细信息
Journal of Materials Research and Technology
Influence of particle shape and size distribution on coating mortar properties
Rodolfo Rabelo Neves1  White José dos Santos2  Antônio Neves de Carvalho Junior2  Lucimar Dias de Oliveira Haddad3  Patrícia Vasconcelos de Oliveira3 
[1] Corresponding author.;Department of Materials Engineering and Construction, Federal University of Minas Gerais, Belo Horizonte, Brazil;Mestrado em Construção Civil, Federal University of Minas Gerais, Belo Horizonte, Brazil;
关键词: Coating mortar;    Aggregate types;    Aggregates grading;    Aggregates shape effect;    Particle packing;   
DOI  :  
来源: DOAJ
【 摘 要 】

This paper investigates the influence of aggregates grading and shape in coating mortar performance, both fresh and hardened stages (mechanical properties and durability). Eight samples of mortar were prepared, using Portland cement type CP II-E-32 (corresponding to American cement: I (SM) ASTM - C 595), natural quartzous aggregate, crushed gneiss artificial aggregate, hydrated lime and water. It was analyzed the packaging of aggregates by determining their grading curves, unitary gravity and void ratio. Aggregates shape was analyzed through images obtained with a stereoscopic magnifying. Regarding coating mortar properties, mechanical properties and durability were analyzed as an aggregates shape function and its granulometric distribution through evaluation of consistency, fresh and hardened state density, air entrained content, water absorption by immersion and porosity, pull-off strength, compressive strength - fc, flexural strength - ft and elasticity modulus - Ed and assessing fissurability. In general, results showed that the particle size curve and the type of aggregate influence significantly the properties analyzed and should be considered during dosing process of coating Portland cement mortar specification, hence many standards to concrete may not be suitable for these composite parts.

【 授权许可】

Unknown   

  文献评价指标  
  下载次数:0次 浏览次数:3次