Behavior

HBRC Journal

Amr Ali Abdelrahman¹  Abdel Wahab EL-Ghandour¹  Tamer Elafandy¹  Hossam-eldin Abd-elazim Elsharkawy² 

[1] Dept. Housing and Building National Research Center, Giza, Egypt;Dept. of Structural Engineering, Ain Shams University, Cairo, Egypt;

关键词: Partially prestressed;    Fully prestressed;    T-shaped;    Steel fibers;    Polypropylene fibers;    Cracks-width;    Flexural strength;    Ductility;    Energy absorption;   

DOI  :  10.1016/j.hbrcj.2013.08.006

来源: DOAJ

【 摘 要 】

This paper presents an experimental and analytical study on the behavior of post-tensioned concrete beams with variable discontinuous fibers’ content. Eleven half scale T-shaped post-tensioned simple beams were cast and tested in four points bending under the effect of a repeated load using a displacement control system up to failure. The test parameters were the fibers’ type (steel and polypropylene) and content, as well as the prestressing ratio (partially or fully). Key test results showed considerable enhancement in the crack distribution, crack width and spacing, concrete tensile strength and flexural stiffness in all beams with steel fibrous concrete. The latter aspects were directly proportional to the steel fibers’ contents. On the other hand, beams containing polypropylene fibers demonstrated a slight decrease in the flexural strength and a slight increase in flexural stiffness. In addition, the tensile steel strains decreased in all fibrous concrete beams, with lowest values in steel fibrous concrete specimens when compared to those of the polypropylene fibers. Furthermore, fibrous concrete beams also demonstrated enhanced ductility and energy absorption, which reached the highest values for steel fibrous concrete specimens. Generally, it can be concluded that steel fibers proved to have higher structural efficiency than polypropylene fibers, when used in the tested specimens.

【 授权许可】

Unknown