Archives of Metallurgy and Materials | |
Analysis Of Drilling Of A Metal Plate With Pilot Hole | |
Kim K.S.1  | |
[1] DIVISION OF MECHANICAL ; | |
关键词: Finite element method; Drilling; Pilot hole; Cutting Force; Plastic Strain; | |
DOI : 10.1515/amm-2015-0119 | |
来源: DOAJ |
【 摘 要 】
This paper performed a numerical analysis study of the cutting characteristics when drilling a taper hole whose upper and lower diameters are different, that is, a pilot hole. 3-dimensional drilling analysis was performed using a commercial code, and these results were used to determine analytically and compare the cutting temperature, the phenomenon of cutting chip formation, deformation and pressure, etc., for the tools, chips, and specimens during cutting. Also, cutting force and the required energy were calculated and compared. To verify the results of analysis, a cutting dynamometer was used to analyze 3-axis cutting force. Results of analysis showed that the specimen maintained a temperature of approximately 650°, with rapid cooling after chips were formed from the specimen. The tool reached a maximum of 700°, similarly to the chips. It is expected that these results will be utilized to optimize cutting processes and work conditions when drilling holes.
【 授权许可】
Unknown