Identification of Residual Stress Phenomena Based on the Hole Drilling Method in Explosively Welded Steel-Titanium Composite

Archives of Metallurgy and Materials

Kowalski M.¹  Kluger K.¹  Karolczuk A.¹  Żok F.² 

[1] OPOLE UNIVERSITY OF TECHNOLOGY, 5 MIKOLAJCZYKA STR., 45-271 OPOLE, POLAND;Z.T.W „EXPLOMET” S.J., 100H OŚWIECIMSKA STR., 45-641 OPOLE, POLAND;

关键词: explosive welding;    residual stresses;    bimetallic composite;    titanium grade 1;   

DOI  :  10.2478/amm-2014-0195

来源: DOAJ

【 摘 要 】

The hole drilling method was used to determine residual stresses in bimetallic composite manufactured by explosive welding process. The analyzed bimetal consist of titanium Grade 1 (6mm) and S355J2+N steel (40mm). The aim of the paper is to establish the influence of the heat treatment on residual stress state in titanium layer. Residual stress calculations were performed according to standards developed by strain gauge manufacturer (TML) and ASTM standards. The main conclusion is the heat treatment considerably changes the residual stress state in titanium layer from tensile stress state (no heat treatment) to compression stress state (after the heat treatment).

【 授权许可】

Unknown