Modelling and transient simulation of water flow in pipelines using WANDA Transient software

Ain Shams Engineering Journal

S. Jones¹  H. Yeung¹  M.N. Eke²  P.U. Akpan² 

[1] Department of Offshore, Process and Energy Engineering, Cranfield University, UK;Mechanical Engineering Department, University of Nigeria, Nsukka, Nigeria;

关键词: Pressure transients;    Water hammer;    Rigid column;    WANDA Transient;    Pipelines;   

DOI  :  10.1016/j.asej.2015.09.006

来源: DOAJ

【 摘 要 】

Pressure transients in conduits such as pipelines are unsteady flow conditions caused by a sudden change in the flow velocity. These conditions might cause damage to the pipelines and its fittings if the extreme pressure (high or low) is experienced within the pipeline. In order to avoid this occurrence, engineers usually carry out pressure transient analysis in the hydraulic design phase of pipeline network systems. Modelling and simulation of transients in pipelines is an acceptable and cost effective method of assessing this problem and finding technical solutions. This research predicts the pressure surge for different flow conditions in two different pipeline systems using WANDA Transient simulation software. Computer models were set-up in WANDA Transient for two different systems namely; the Graze experiment (miniature system) and a simple main water riser system based on some initial laboratory data and system parameters. The initial laboratory data and system parameters were used for all the simulations. Results obtained from the computer model simulations compared favourably with the experimental results at Polytropic index of 1.2.

【 授权许可】

Unknown