TiO2 Nanotubes with Pt and Pd Nanoparticles as Catalysts for Electro-Oxidation of Formic Acid

Materials

Mariusz Andrzejczuk¹  Piotr Kędzierzawski²  Anna Mikołajczuk-Zychora²  Andrzej Borodziński²  Maria Janik-Czachor²  Marcin Hołdyński²  Marcin Pisarek² 

[1] Faculty of Materials Science and Engineering, Warsaw University of Technology, Woloska Str. 141, 02-507 Warsaw, Poland;Institute of Physical Chemistry, Polish Academy of Sciences, Kasprzaka Str. 44/52, 01-224 Warsaw, Poland;

关键词: tio₂ nanotubes;    pt and pd nanoparticles;    surface and structure characterization;    electrocatalysis;    formic acid fuel cell;   

DOI  :  10.3390/ma13051195

来源: DOAJ

【 摘 要 】

In the present work, the magnetron sputtering technique was used to prepare new catalysts of formic acid electrooxidation based on TiO₂ nanotubes decorated with Pt (platinum), Pd (palladium) or Pd + Pt nanoparticles. TiO₂ nanotubes (TiO₂ NTs) with strictly defined geometry were produced by anodization of Ti foil and Ti mesh in a mixture of glycerol and water with ammonium fluoride electrolyte. The above mentioned catalytically active metal nanoparticles (NPs) were located mainly on the top of the TiO₂ NTs, forming ‘rings’ and agglomerates. A part of metal nanoparticles decorated also TiO₂ NTs walls, thus providing sufficient electronic conductivity for electron transportation between the metal nanoparticle rings and Ti current collector. The electrocatalytic activity of the TiO₂ NTs/Ti foil, decorated by Pt, Pd and/or Pd + Pt NPs was investigated by cyclic voltammetry (CV) and new Pd/TiO₂ NTs/Ti mesh catalyst was additionally tested in a direct formic acid fuel cell (DFAFC). The results so obtained were compared with commercial catalyst—Pd/Vulcan. CV tests have shown for carbon supported catalysts, that the activity of TiO₂ NTs decorated with Pd was considerably higher than that one decorated with Pt. Moreover, for TiO₂ NTs supported Pd catalyst specific activity (per mg of metal) was higher than that for well dispersed carbon supported commercial catalyst. The tests at DFAFC have revealed also that the maximum of specific power for 0.2 Pd/TiO₂ catalyst was 70% higher than that of the commercial one, Pd/Vulcan. Morphological features, and/or peculiarities, as well as surface composition of the resulting catalysts have been studied by scanning electron microscopy (SEM), scanning transmission electron microscopy (STEM), and chemical surface analytical methods (X-ray photoelectron spectroscopy—XPS; Auger electron spectroscopy—AES).

【 授权许可】

Unknown