Ability of non-destructive assay techniques to identify sophisticated material partial defects

Nuclear Engineering and Technology

Braden Goddard¹  Cody Lloyd² 

[1] Virginia Commonwealth University, Department of Mechanical and Nuclear Engineering, 401 West Main Street P.O. Box 843015, Richmond, VA, 23284-3015, USA;Corresponding author.;

关键词: Material defects;    Plutonium;    Californium;   

DOI  :  

来源: DOAJ

【 摘 要 】

This study explores the ability of non-destructive assay techniques to detect a partial material defect in which 100 g of plutonium are diverted from the center of a 1000 g can of PuO2 powder. Four safeguards measurements techniques: neutron multiplicity counting, calorimetry, gravimetry, and gamma ray spectroscopy are used in an attempt to detect the defect. Several materials are added to the partial defect PuO2 can to replicate signatures of the diverted material. 252Cf is used to compensate for the doubles neutron counts, 241Am is used to compensate for the decay heat, and aluminum is used to compensate for the weight. Although, the doubles and triples difference before and after diversion are statistically indistinguishable with the AWCC in fast and thermal mode, the difference in the singles counts are statistically detectable in both modes. The relatively short half-life of 252Cf leads to a decrease (three sigma uncertainty) in the doubles neutron counts after 161 days. Combining this with the precise quantity of 241Am needed (10.7 g) to mimic the heat signature and the extreme precision in 252Cf mass needed to defeat neutron multiplicity measurements gives reassurance in the International Atomic Energy Agency's ability to detect partial material defects.

【 授权许可】

Unknown