Behavior of Non-Shear-Strengthened UHPC Beams under Flexural Loading: Influence of Reinforcement Depth

Applied Sciences

Yassir M. Abbas¹  Galal Fares¹  Mohammad Iqbal Khan¹ 

[1] Department of Civil Engineering, King Saud University, Riyadh 800-11421, Saudi Arabia;

关键词: ultra-high-performance concrete (UHPC);    moment capacity;    RC beams;    hybrid fiber;    ductility;   

DOI  :  10.3390/app112311168

来源: DOAJ

【 摘 要 】

This study was carried out in order to study the flexural behavior of fiber-reinforced ultra-high-performance concrete (UHPC) containing hybrid microsteel straight fibers and natural fine aggregates under four-point flexural loading. The experimental results revealed that the fiber pullout mechanism had a progressive pullout (collapse) mode. A highly flexural crack developed when the fiber pulling mechanism was explicitly triggered, leading to the failure of most beams. The maximum load in beams reinforced by 1.2, 1.6, and 2.0% exceeded that in beams without longitudinal reinforcement by 56, 73, and 94%, respectively. Further, bar reinforcements at 125, 115, 95, 85, and 75 mm depths led to increases of 56, 55, 73, 96, and 94% in beam load capacity, respectively. In addition, bar reinforcement at 115, 95, 85, and 75 mm depths reduced the beams’ ductility by 40, 23, 35, and 39% compared to those with 125 mm depth. All studied UHPC beams had an uncracked phase that extended to a curvature of about 7.5 × 10⁻⁶ rad, which occurred at about 10 kNm. The use of the design of experiments was exploited in this investigation to develop a prediction model for the ultimate moment capacity of UHPC beams. This prediction model took into account the sectional and material properties of UHPC beams. To carry out this analysis, a database of 25 beams, developed by other investigators, as well as the present authors, was utilized. With a mean prediction-to-test ratio of 0.92, this prediction model had a reasonable performance capacity. In turn, this model was used to generate isoresponsive surface contours that could be used for UHPC beam design.

【 授权许可】

Unknown