A transient flow solution to describe fluid flow to horizontal fractures applied to frac‐packed wells

Energy Science & Engineering

Ning Liu¹  Chunkai Fu¹  Boyun Guo¹ 

[1] Department of Petroleum Engineering University of Louisiana at Lafayette Lafayette Louisiana USA;

关键词: analytical modeling;    curve matching;    frac‐pack;    horizontal fracture;    transient flow;   

DOI  :  10.1002/ese3.962

来源: DOAJ

【 摘 要 】

Abstract This paper presents an analytical model to describe the transient fluid flow to a horizontal fracture in frac‐packed vertical wells. A physical model is first established where a horizontal frac‐packed fracture is located in the middle of a cylindrical reservoir. The pressure distribution in the fracture is then derived concerning time and the distance to the wellbore. The analytical model assumes a homogeneous and isotropic reservoir where Darcy's law applies to a single‐phase fluid flow, a radial fracture with a radius much greater than pay zone thickness, and a constant fracture width. For ease of application, a Type Curve Matching approach is introduced which features the matching of a defined dimensionless pressure between field pressure data and model data, and some exemplar curves are illustrated in this paper. The principle of applying curve matching here is to tune model parameters to match the measured pressure/rate data. Once the curves are matched, the model parameters, that is, fracture permeability, etc, are naturally obtained. The validity of the derived model is informed in two ways. The results show that the model will degenerate to the classic radial flow equation for practical values of certain model parameters and upon reasonable simplification. Model validity is further verified by applying the type curve matching technique using field data. This model can be used as a quick and reasonable method to analyze the transient pressure/rate test data to reveal fundamental fracture and reservoir properties for a frac‐packed horizontal fracture at shallow depths where the vertical formation stress is the least in situ stress.

【 授权许可】

Unknown