An Experimental and Numerical Study on the Use of Chirped FBG Sensors for Monitoring Fatigue Damage in Hybrid Composite Patch Repairs

Sensors

StephenL. Ogin¹  AndrewD. Crocombe¹  RodolfoL. Rito¹ 

[1] Department of Mechanical Engineering Sciences, Faculty of Engineering and Physical Sciences, University of Surrey, Guildford U2 7XH, UK;

关键词: structural health monitoring;    chirped fibre bragg grating;    fibre reinforced plastic;    finite element analysis (FEA);    fatigue delamination;   

DOI  :  10.3390/s21041168

来源: DOAJ

【 摘 要 】

In this paper, chirped fibre Bragg grating (CFBG) sensors used to monitor the structural health of a composite patch used to repair an aluminium panel is presented. To introduce damage, a notch was produced at the centre of an aluminium panel. The repair consisted of bonding a pre-cured composite patch to the host panel using an aerospace-grade film adhesive; the sensor was embedded in the bond-line during fabrication of the repair. The repaired panels were subjected to tension-tension loading in fatigue. Cracks initiated and grew from both ends of the notch in the aluminium panels and the fatigue loading was stopped periodically for short periods of time to record the reflected spectra from the sensor. It was found that perturbations in the reflected spectra began to occur when the crack was within about 2 to 3 mm of the sensor location; after the crack passed the sensor location, the perturbations essentially stabilised. Predicted reflected spectra have been found to be in good agreement with the experiment, confirming that CFBG sensors can detect crack growth in patch-repaired panels.

【 授权许可】

Unknown