Analysis of the Parameters of the Two-Sections Hot Side Heat Exchanger of the Module with Thermoelectric Generators

Energies

Andrzej Majcher¹  Mirosław Mrozek¹  Mirosław Neska¹  Marta Żurek-Mortka¹ 

[1] Łukasiewicz Research Network—Institute for Sustainable Technologies, 26-600 Radom, Poland;

关键词: thermoelectric generators;    heat exchangers;    waste heat;    thermocouple;   

DOI  :  10.3390/en14165169

来源: DOAJ

【 摘 要 】

One of the methods of converting thermal energy into electricity is the use of thermoelectric generators (TEG). The method can be used in low-temperature waste heat conversion systems from industrial installations, but its serious limitation is the low efficiency of thermolectric generators and the relatively low power of the electric waveforms obtained. Increasing the obtained power values is done by multiplying the number of TEGs used, grouped into modules (MTEG). In such systems, the design of the module is extremely important, as it should ensure the best possible heat transfer between both sides of the TEG (hot and cold), and thus obtaining maximum electrical power. The article presents an analysis of a two-section flat plate heat hot side exchanger MTEG. The key parameters like effectiveness of exchange and MTEG efficiency and their impact on the efficiency of heat use and generated electric power were indicated. The tests showed an improvement in these main system parameters for the mixed cycle (co-current and countercurrent—inward direction) of the hot side heat exchanger, compared to the countercurrent flow in both sections of this exchanger.

【 授权许可】

Unknown