The Bent-Tube Nozzle Optimization of Force-Spinning With the Gray Wolf Algorithm

Frontiers in Bioengineering and Biotechnology

Kang Liu¹  Peiyan Ye²  Zijun Wu²  Qiaoling Ji²  Zhiming Zhang²  Wenhui Li² 

[1] Hubei Digital Textile Equipment Key Laboratory, Wuhan Textile University, Wuhan, China;School of Mechanical Engineering and Automation, Wuhan Textile University, Wuhan, China;

关键词: force-spinning;    nanofibers;    spinneret;    optimization;    gray wolf algorithm;   

DOI  :  10.3389/fbioe.2021.807287

来源: DOAJ

【 摘 要 】

Force-spinning is a popular way to fabricate various fine fibers such as polymer and metal nanofibers, which are being widely employed in medical and industrial manufacture. The spinneret is the key of the device for spinning fibers, and the physical performance and morphology of the spun nanofibers are largely determined by its structure parameters. In this article, the effect of spinneret parameters on the outlet velocity is explored and the spinneret parameters are also optimized to obtain the maximum outlet velocity. The mathematical model of the solution flow in four areas is established at first, and the relationship between outlet velocity and structure parameters is acquired. This model can directly reflect the flow velocity of the solution in each area. Then, the optimal parameters of outlet diameter, bending angle, and curvature radius are obtained combined with the gray wolf algorithm (GWA). It is found that a curved-tube nozzle with a bending angle of 9.1°, nozzle diameter of 0.6 mm, and curvature radius of 10 mm can obtain the maximum outlet velocity and better velocity distribution. Subsequently, the simulation is utilized to analyze and compare the velocity situation of different parameters. Finally, the fiber of 5 wt% PEO solution is manufactured by a straight-tube nozzle and optimized bent-tube nozzle in the laboratory, and the morphology and diameter distribution were observed using a scanning electron microscope (SEM). The results showed that the outlet velocity was dramatically improved after the bent-tube parameters were optimized by GWA, and nanofibers of better surface quality could be obtained using optimized bent-tube nozzles.

【 授权许可】

Unknown