Simultaneous estimation of in situ porosity and thermal structure from core sample measurements and resistivity log data at Nankai accretionary prism

Earth, Planets and Space

Gaku Kimura¹  Rina Fukuchi²  Suguru Yabe³  Yohei Hamada⁴ 

[1] Department of Marine Environment and Resources, Tokyo University of Marine Science and Technology;Geoengineering Headquarters, Dia Consultants Co., Ltd.;Geological Survey of Japan, National Institute of Advanced Industrial Science and Technology (AIST);Institute for Extra-cutting-edge Science and Technology Avant-garde Research, Kochi Institute for Core Sample Research, Japan Agency for Marine-Earth Science and Technology;

关键词: Accretionary prism;    Subduction zones;    Logging data;    Electrical resistivity;    In situ porosity;    Thermal structure;   

DOI  :  10.1186/s40623-019-1097-4

来源: DOAJ

【 摘 要 】

Abstract The shallow accretionary prism of the Nankai Trough is a location where both large interplate earthquakes and slow earthquakes occur. Since the physical properties of sedimentary materials are important topics for understanding the structure of the prism, numerous ocean drilling expeditions have been conducted in that region to obtain logging data and core samples. Although the physical properties of the obtained samples are normally measured onboard immediately after coring, estimations of in situ physical properties are difficult because of differences in laboratory and in situ physical conditions. Herein, we propose a new method for estimating in situ porosity from downhole electrical resistivity log data that evaluates in situ porosity and thermal structure simultaneously using correlations between the porosity and resistivity, and between the porosity and thermal conductivity that were established based on laboratory measurements. When constructing physical property correlations, X-ray computed tomography data play an important role in estimating the porosity of samples from which resistivity or thermal conductivity were measured. To validate our method, we compared the estimation with density log data collected at Site C0002 and found that the estimated in situ porosity shows good agreement with the in situ porosity converted from density log data. A comparison with porosity measured onboard for core and cutting samples showed that they are consistent with each other. With this new method, continuous distributions of in situ porosity and thermal structure can be estimated simultaneously based on resistivity log data and heat flow, which are basic quantities acquired during ocean drilling science expeditions.

【 授权许可】

Unknown