Control of the Nano-Particle Weight Ratio in Stainless SteelMicro and Nano Powders by Radio FrequencyPlasma Treatment

Metals

Min Young Hur¹  Hae June Lee¹  Yong-Jin Kim²  Youngja Kim²  Sangsun Yang²  Tae-Soo Lim²  Dong-Yeol Yang²  Ki-Bong Kim² 

[1] Department of Electrical Engineering, Pusan National University, Busan 609-735, Korea;Powder & Ceramics Division, Korea Institute of Materials Science, Changwon 642-831, Korea;

关键词: metal powder;    micro-/nano-powder;    RF plasma treatment;    metal injection molding;    microelectronics;    stainless steel;   

DOI  :  10.3390/met5042058

来源: DOAJ

【 摘 要 】

This study describes how to make stainless steel hybrid micro-nano-powders(a mixture of micro-powder and nano-powder) using an in situ one-step process via radio frequency (RF) thermal plasma treatment. Nano-particles attached to micro-powders were successfully prepared by RF thermal plasma treatment of stainless steel powder with an average size of 35 μm. The ratio of nano-powders is estimated with a two-dimensional fluid simulation that calculates the temperature profile influencing the rate of surface evaporation. The simulation is conducted to determine the variation of the input power and the distance from the plasma torch to the feeding nozzle. It was demonstrated experimentally that the nano-powder ratio in the micro-nano-powder mixture can be controlled by adjusting the feeding rate, plasma power, feeding position and quenching effect during plasma treatment. The ratio of nano-particles in the micro-nano-powder mixture was controlled in a range from 0.1 (wt. %) to 30.7 (wt. %).

【 授权许可】

Unknown