Mining Stress Distribution and Fault-Slip Behavior: A Case Study of Fault-Influenced Longwall Coal Mining

Energies

Jiaming Shu¹  Lu Wang¹  Peng Kong¹  Lishuai Jiang¹ 

[1] State Key Laboratory of Mining Disaster Prevention and Control, Shandong University of Science and Technology, Qingdao 266590, China;

关键词: coal;    microseismicity;    fault slip;    numerical simulation;    mining stress;   

DOI  :  10.3390/en12132494

来源: DOAJ

【 摘 要 】

It is well accepted that faults have significant impacts on the safe production of underground coal mines; however, the fault-slip mechanism during longwall mining through a fault still needs to be investigated. In this study, the distribution of microseismicity events during panel mining through a fault is analyzed, and 3-dimensional fast Lagrangian analysis of continua was used to study the mining stress distribution and fault-slip behavior under the two different mining directions, i.e., mining the panel through the fault from the footwall, or mining the panel through the fault from the hanging wall. The research shows that when the panel is mined through the fault from the footwall, the shear displacement of the fault is significantly greater than those created by mining the panel through the fault from the hanging wall. Under the two mining directions, the variation behaviors of the normal stress and shear stress on the fault are quite different, and fault-slips mainly occur in fault areas where the normal stress decreases. When mining the panel through the fault from the footwall, the slip mainly occurs in the coal-seam roof fault, and when mining the panel through the fault from the hanging wall, the slip mainly occurs in the coal-seam floor fault. According to the variations in the normal stress and shear stress of the fault during the period of mining the panel through the fault, the mechanism of the fault slip can be divided into three categories. 1: Normal stress and shear stress decrease abruptly, but the reduction of the normal stress is greater than that of the shear stress. 2: The normal stress is continuously reduced, the shear strength of the fault is decreased, and the shear stress is suddenly increased. 3: Both the normal stress and the shear stress increase, but the increase in the shear stress is greater than that of the normal stress. These research results can provide a reference for the layout of panels and for fault-slip-induced disaster prevention under similar conditions.

【 授权许可】

Unknown