Physical Similarity Simulation of Deformation and Failure Characteristics of Coal-Rock Rise under the Influence of Repeated Mining in Close Distance Coal Seams

Energies

Guiyi Wu¹  Lin Gao¹  Dezhong Kong¹  Yongyin Wang¹  Zhenqian Ma¹  Pengze Liu¹  Ping Liu¹  Pandong Zhang¹  Sen Han¹  Xiangtao Kang¹ 

[1] College of Mining, Guizhou University, Guiyang 550025, China;

关键词: similar simulation test;    precise excavation of roadway;    repeated mining;    coal-rock roadway;    infrared thermal image;   

DOI  :  10.3390/en15103503

来源: DOAJ

【 摘 要 】

Aiming at the problem that it is difficult to achieve accurate laying of model and precise excavation of roadways in special surrounding rock structure roadway according to conventional physical similarity simulation, which reduces the reliability of experimental results. An accurate laying of model and precise excavation of roadway method, named “labeling positioning and drawing line, presetting roadway model” (LPDLPRM), was proposed. The physical similarity simulation of deformation and failure characteristics of surrounding rock of coal-rock rise, under the influence of repeated mining in close distance coal seams, was carried out based on the method and infrared detection. The results show that the coal-rock rise in close distance coal seams was affected by repeated mining disturbances, and the surrounding rock of coal-rock rise was characterized by obvious asymmetric deformation, specific for the stress and strain near the coal pillar were higher than that of other parts, and cracks near the coal pillar were denser than other parts; when the coal seam is mined in which the coal-rock rise is located, the stress concentration of the surrounding rock near the rise was weakened by mining pressure relief in the upper coal seam; the stress concentration of the surrounding rock near the rise increases when the coal and the lower coal seam are mined, and the stress on the right side (coal pillar side) near the coal-rock rise was the most concentrated. Therefore, it is important to take measures to strengthen support near the coal pillar and to control asymmetric deformation when the coal-rock rise is influenced by repeated mining.

【 授权许可】

Unknown