60% Efficient Monolithically Wavelength-Stabilized 970-nm DBR Broad-Area Lasers

IEEE Photonics Journal

Paul Crump¹  Jorg Fricke¹  Martin Wilkens²  Andrea Knigge²  Hans Wenzel³  Md. Jarez Miah³ 

[1] Ferdinand-Braun-Institut gGmbH, Leibniz-Institut f&x00FC;chstfrequenztechnik, Berlin, Germany;r H&x00F6;

关键词: Beam parameter product;    beam quality;    broad-area lasers;    DBR lasers;    far-field;    high power lasers;   

DOI  :  10.1109/JPHOT.2022.3166591

来源: DOAJ

【 摘 要 】

Progress in epitaxial design is shown to enable increased optical output power P_opt and power conversion efficiency η_E and decreased lateral far-field divergence angle in GaAs-based distributed Bragg reflector (DBR) broad-area (BA) diode lasers. We show that the wavelength-locked power can be significantly increased (saturation at high bias current is mitigated) by migrating from an asymmetric large optical cavity (ASLOC) based laser structure to a highly asymmetric (extreme-triple-asymmetric (ETAS)) layer design. For wavelength-stabilization, 7^th order, monolithic DBRs are etched on the surface of fully grown epitaxial layer structures. The investigated ETAS reference Fabry-Pérot (FP) BA lasers without DBRs and with 200 µm stripe width and 4 mm cavity length provide P_opt = 29 W (still increasing) at 30 A in continuous-wave mode at room temperature, in contrast to the maximum P_opt = 24 W (limited by strong power saturation) of baseline ASLOC lasers. The reference ETAS FP lasers also deliver over 10% higher η_E at P_opt = 24 W. On the other hand, in comparison to the wavelength-stabilized ASLOC DBR lasers, ETAS DBR lasers show a peak power increment from 14 W to 22 W, and an efficiency increment from 46% to 60% at P_opt = 14 W. A narrow spectral width (< 1 nm at 95% power content) is maintained across a very wide operating range. Consistent with earlier studies, a narrower far-field divergence angle and consequently an improved beam-parameter product is also observed, compared to the ASLOC-based lasers.

【 授权许可】

Unknown