A Strain-Transfer Model of Surface-Bonded Sapphire-Derived Fiber Bragg Grating Sensors

Applied Sciences

Shuang Chen¹  Li Zhang¹  Zhongyu Wang²  Penghao Zhang²  Zhendong Shang³ 

[1] Changcheng Institute of Metrology and Measurement, Huanshan Village, Wenquan Town, Haidian District, Beijing 100095, China;School of Instrumentation Science and Opto-electronics Engineering, Beihang University, Xueyuan Road No. 37, Haidian District, Beijing 100191, China;School of Mechatronics Engineering, Henan University of Science and Technology, Xiyuan Road No. 48, Jianxi District, Luoyang 471000, Henan Province, China;

关键词: strain transfer;    sapphire-derived fiber;    Bragg grating;    core radius;    alumina content;   

DOI  :  10.3390/app10124399

来源: DOAJ

【 摘 要 】

An improved strain-transfer model was developed for surface-bonded sapphire-derived fiber Bragg grating sensors. In the model, the core and cladding of the fiber are separated into individual layers, unlike in conventional treatment that regards the fiber as a unitive structure. The separation is because large shear deformation occurs in the cladding when the core of the sapphire-derived fiber is heavily doped with alumina, a material with a high Young’s modulus. Thus, the model was established to have four layers, namely, a core, a cladding, an adhesive, and a host material. A three-layer model could also be obtained from the regressed four-layer model when the core’s radius increased to that of the cladding, which treated the fiber as if it were still homogeneous material. The accuracy of both the four- and three-layer models was verified using a finite-element model and a tensile-strain experiment. Experiment results indicated that a larger core diameter and a higher alumina content resulted in a lower average strain-transfer rate. Error percentages were less than 1.8% when the four- and three-layer models were used to predict the transfer rates of sensors with high and low alumina content, respectively.

【 授权许可】

Unknown