INVESTIGATION OF CUTTING FORCE IN HARDENED STEEL TURNING

Učenye Zapiski Komsomolʹskogo-na-Amure Gosudarstvennogo Tehničeskogo Universiteta

Mr. Vladimir V. Mylnikov¹  Mr. Yevgeny B. Shchelkunov²  Mr. Alexander I. Pronin²  Ms. Marina Ye. Shchelkunova²  Mr. Sergey V. Vinogradov² 

[1] Nizhny Novgorod State Technical University n.a. R.E. Alekseev;Комсомольский-на-Амуре государственный технический университет;

关键词: cutting ceramics;    hardened steel;    cutter;    hard turning;    cutting speed;    cutting feed;    cutting force;   

DOI  :  10.17084/2016.IV-1(28).8

来源: DOAJ

【 摘 要 】

The paper presents results of the processing parameter effect, i.e. the magnitude of cutting speed and cutting force component feedin turning of hardened steel grades 45, 40X, 50X, CVH hardness 45..50 HRC with the help of the tool equipped with cutting ceramics EQA-60. The laboratory bench has been used for experimental studies, including a screw-cutting lathe 1K625 and the measuring device STD.201-2. The presence of the cutting speed range providing the minimum magnitude of the cutting force components is established.

【 授权许可】

Unknown