Experimental investigation on low-frequency vibration assisted micro-WEDM of Inconel 718

Engineering Science and Technology, an International Journal

关键词: Micro-wire electric discharge machining;    Low-frequency;    Vibration;    Micro-channels;    Surface quality;    MRR;    Kerf;   

DOI  :  10.1016/j.jestch.2016.06.010

来源: DOAJ

【 摘 要 】

The micro-wire electric discharge machining (micro-WEDM) has emerged as the popular micromachining processes for fabrication of micro-features. However, the low machining rate and poor surface finish are restricting wide applications of this process. Therefore, in this study, an attempt was made to improve machining rate of micro-WEDM with low-frequency workpiece vibration assistance. The gap voltage, capacitance, feed rate and vibrational frequency were chosen as control factors, whereas, the material removal rate (MRR) and kerf width were selected as performance measures while fabricating microchannels in Inconel 718. It was observed that in micro-WEDM, the capacitance is the most significant factor affecting both MRR and kerf width. It was witnessed that the low-frequency workpiece vibration improves the performance of micro-WEDM by improving the MRR due to enhanced flushing conditions and reduced electrode-workpiece adhesion.

【 授权许可】

Unknown