Impact of keel saw blade design and thickness on the incidence of tibial plateau fracture and tibial implant-loosening in cementless medial UKR

BMC Musculoskeletal Disorders

Lena Keppler¹  Alexander Martin Keppler²  Kilian Voigts³  Steffen Klingbeil³  Björn Michel³  Christian Fulghum³  Wolfgang Reng³  Johannes Becker³ 

[1] BG Trauma Center Murnau, Trauma Surgery;Department of Orthopaedics and Trauma Surgery, Musculoskeletal University Center Munich (MUM), University Hospital, LMU Munich;Klinikum Garmisch-Partenkirchen, Endogap, Joint Replacement Institute;

关键词: Fracture incidence;    Revision surgery;    Outcome;    Influence;    Saw blade;   

DOI  :  10.1186/s12891-022-05500-9

来源: DOAJ

【 摘 要 】

Abstract Background Tibial plateau fractures and tibial implant- loosening are severe complications in cementless unicompartmental knee replacement (UKR). The tibial keel preparation is particularly demanding and different saw blades can be used. It was hypothesized that different blade designs and thickness have an influence on the frequency of tibial plateau fractures and implant-loosening in cementless medial UKR. Methods 1258 patients with cementless medial UKR were included in this retrospective study between 2013 and 2020. The tibial keel cut was performed either with a double keel saw blade (DKS; 2.8 mm) and added hand guided pick or a mono reciprocating saw blade (RKB) of different thickness (2.5 mm; 2.65 mm; 2.75 mm). Tibial plateau fracture and loosening were demonstrated by standard two-plane radiographs. Tibial implant-loosening was defined as complete radiolucency and implant migration. Fracture and loosening were combined with pain and loss of function. Results In 126 patients (10%) the tibial keel was prepared with DKS, in 407 patients (32.4%) with RKB 2.5 mm, in 330 patients (26.2%) with RKB 2.65 mm and in 395 patients (31.4%) with 2.75 mm. In 4 patients (3.17%) with DKS tibial plateau fracture occurred, in 4 patients (0.99%) with 2.5 mm RKB, in 3 patients (0.92%) with 2.65 mm RKB and in 1 patient (0.25%) with 2.75 mm RKB. Significantly fewer fractures occurred with a RKB design (p = 0.007). A negative correlation between fracture incidence and RKB saw blade thickness was found (Spearman-r = − 0.93). No difference for tibial implant-loosening was shown (p = 0.51). Conclusion Different blade designs and thickness have a significant influence on the incidence of tibial plateau fractures and aseptic tibial implant-loosening. The incidence of tibial plateau fractures in cementless medial UKR can be reduced by changing the design and thickness of the tibial keel saw blade. Greater thickness of RKB leads to significantly fewer tibial plateau fractures while the incidence of implant-loosening is not increasing. Trial registration: This study was retrospectively registered and ethical approval was waived by the local ethical committee (No. 2020–1174).

【 授权许可】

Unknown