Fast scanning calorimetry study of Al alloy powder for understanding microstructural development in laser powder bed fusion

Materials & Design

Mulin Liu¹  Naoki Takata²  Asuka Suzuki³  Hongmei Li³  Makoto Kobashi³ 

[1] Department of Materials Process Engineering, Graduate School of Engineering, Nagoya University, Furo-cho, Chikusa-ku, Nagoya 464-8603 Japan;Corresponding author.;Department of Materials Process Engineering, Graduate School of Engineering, Nagoya University, Furo-cho, Chikusa-ku, Nagoya 464-8603 Japan;

关键词: Additive manufacturing;    Selective laser melting;    Al–Si alloy;    Rapid solidification;    Cooling rate;    Fast scanning calorimetry;   

DOI  :  

来源: DOAJ

【 摘 要 】

We examined the variation in the solidification microstructure of AlSi10Mg alloy powder over a wide range of cooling rates controlled by using the fast scanning calorimetry (FSC) technique. Two exothermic peaks derived from the primary solidification of the α-Al phases and the α-Al/Si eutectic reaction were detected. These exothermic peaks became broader and shifted to lower temperatures at higher cooling rates. Focus ion beam (FIB) milling enables microstructural characterization of AlSi10Mg powder solidified at controlled cooling rates above 102 °C·s−1 in the FSC equipment. The sample solidified at 4 × 104 °C·s−1 exhibited a fine microstructure consisting of a primary α-Al phase surrounded by lamellar-shaped Si phases. The fraction of the Si phase continuously decreased with increasing cooling rate, indicating higher content of solute Si element in the α-Al phase solidified at a higher cooling rate. The secondary dendrite arm spacing (λ) of the primary α-Al phase decreased in the sample solidified at a higher cooling rate (dT/dt). The relation follows a general equation of λ = A (dT/dt)-n (A: 38.4, n: 0.33) in wide range of cooling rate (10-1 ∼ 104 °C·s−1). The results were utilized to discuss the cooling rate of Al alloys during the laser powder bed fusion (L-PBF) process.

【 授权许可】

Unknown