Printed Smart Devices on Cellulose-Based Materials by means of Aerosol-Jet Printing and Photonic Curing

Sensors

Michela Borghetti¹  Mauro Serpelloni¹  Edoardo Cantù¹  Emilio Sardini¹ 

[1] Department of Information Engineering, University of Brescia, Via Branze 38, 25123 Brescia, Italy;

关键词: printed electronics;    paper-based circuit;    paper-based hybrid circuit;    aerosol jet printing;    photonic curing;   

DOI  :  10.3390/s20030841

来源: DOAJ

【 摘 要 】

Printed electronics is an expanding research field that can reach the goal of reducing the environmental impact on electronics exploiting renewable and biodegradable materials, like paper. In our work, we designed and tested a new method for fabricating hybrid smart devices on cellulose substrates by aerosol jet printing (AJP) and photonic curing, also known as flash lamp annealing (FLA), capable to cure low temperature materials without any damage. Three different cellulose-based materials (chromatographic paper, photopaper, cardboard) were tested. Multilayer capability and SMDs (surface mount devices) interconnections are possible permitting high flexibility in the fabrication process. Electrical and geometrical tests were performed to analyze the behavior of printed samples. Resulted resistivities are 26.3 × 10⁻⁸ Ω⋅m on chromatographic paper, 22.3 × 10⁻⁸ Ω⋅m on photopaper and 13.1 × 10⁻⁸ Ω⋅m on cardboard. Profilometer and optical microscope evaluations were performed to state deposition quality and penetration of the ink in cellulose materials (thicknesses equal to 24.9, 28.5, and 51 μm respectively for chromatographic paper, photopaper, and cardboard). Furthermore, bending (only chromatographic paper did not reach the break-up) and damp environment tests (no significant variations in resistance) where performed. A final prototype of a complete functioning multilayer smart devices on cellulose 3D-substrate is shown, characterized by multilayers, capacitive sensors, SMDs interconnections.

【 授权许可】

Unknown