Establishing the Relationship between Cutting Speed and Output Parameters in Belt Grinding on Steels, Aluminum and Nickel Alloys: Development of Recommendations

Materials

NelliVladimirovna Syreyshchikova¹  DanilYurievich Pimenov¹  MunishKumar Gupta¹  Shubham Sharma²  Krzysztof Nadolny³  Khaled Giasin⁴ 

[1] Department of Automated Mechanical Engineering, South Ural State University, Lenin Prosp. 76, 454080 Chelyabinsk, Russia;Department of Mechanical Engineering, Main Campus-Kapurthala, IK Gujral Punjab Technical University, Punjab 144603, India;Department of Production Engineering, Faculty of Mechanical Engineering, Koszalin University of Technology, Racławicka 15-17, 75-620 Koszalin, Poland;School of Mechanical and Design Engineering, University of Portsmouth, Portsmouth PO1 3DJ, UK;

关键词: surface belt grinding;    machining;    cutting speed;    surface roughness;    material removal rate (MRR);   

DOI  :  10.3390/ma14081974

来源: DOAJ

【 摘 要 】

This paper presents the research results of one of the main technological parameters of belt grinding, i.e., the cutting speed while machining corrosion- and heat-resistant, structural carbon and structural alloy steels, aluminum, and heat-resistant nickel alloys. Experimental and analytical methods are used to establish the dependence of the output parameters of surface belt grinding on the cutting speed and tool characteristics. An analytical model, considering the physical and mechanical properties of the grinding belt (strength depending on the base and bond; the thermal conductivity; the type of grinding operation) and the machined material, is created to determine the belt grinding speed. The output parameters, such as the arithmetic mean of the surface roughness (Ra) and the material removal rate (MRR) during the belt grinding of steels, heat-resistant and light alloys, have been studied. Based on the empirical dependencies of the belt grinding parameters, the model was developed for the selection and setting of the cutting speed of belt grinding for the aforementioned alloys, taking into account the type of operation, the type of the machined material, and the main characteristics of the sanding belt.

【 授权许可】

Unknown