Material flow control in plunge micro rotary swaging

MATEC Web of Conferences

关键词: Metal forming;    Process control;    Geometry;   

DOI  :  10.1051/matecconf/201819015014

来源: DOAJ

【 摘 要 】

In rotary swaging, the material flow is not fully controlled by closure of the forming dies. This is especially noticeable in plunge rotary swaging of rod, where the workpiece is positioned into the forming zone und processed locally. As result, an uncontrolled elongation of the workpiece in axial direction takes place and an axial position shift of the workpiece relative to the dies occurs. This is a special challenge in production of linked micro parts, where single parts are interconnected in order to enable the handling as a strip and thereby a roll-to-roll production. The axial shift influences not only the subsequent positioning of neighbouring parts, but also the final geometry of the currently processed part. The presented investigation analyses the material flow during plunge micro rotary swaging on basis of in-process measurements of the workpiece shift on both sides of the forming zone as well as with the help of contour measurements of the processed parts. It is shown that the measured shift is strongly influenced by the workpiece clamping and fixation and that it can be controlled by applying low axial forces to the workpiece on one or both sides of the forming zone. Further, the geometry of the workpiece can be affected by these measures.

【 授权许可】

Unknown