Amelioration of pool boiling thermal performance in case of using a new hybrid nanofluid

Case Studies in Thermal Engineering

Ali Abdollahi¹  Ferenc Lezsovits²  Mohsen Izadi³  Mohammed Saad Kamel³ 

[1] Corresponding author. Department of Energy Engineering, Faculty of Mechanical Engineering, Budapest University of Technology and Economics, 1111, Budapest, Műegyetem rkp3, Hungary.;Department of Mechanical Techniques, Al-Nasiriya Technical Institute, Southern Technical University, 64001, Thi-Qar, Iraq;Department of Energy Engineering, Faculty of Mechanical Engineering, Budapest University of Technology and Economics, 1111, Budapest, Műegyetem rkp3, Hungary;

关键词: Pool boiling, Al2O3 , CeO2 , hybrid nanofluids;    PBHTC;    Thermal performance;   

DOI  :  

来源: DOAJ

【 摘 要 】

Unremitting endeavors have been devoted by numerous researchers to ameliorate thermal performance of pool boiling by reducing the superheat temperature value using various approaches. This study aims to experimentally investigate the pool boiling thermal performance of Al2O3 and CeO2 hybrid nanoparticles with 50:50 mixing ratio based deionizedc1 water at atmospheric pressure condition. The pool boiling curves, pool boiling heat transfer coefficient PBHTC enhancement ratio with different dilute volumetric concentrations ranging (0.01–0.1% Vol.) from horizontal typical copper tube were examined. Results demonstrated that the enhancement ratio for hybrid nanofluid was improved compared to DI water, and the higher enhancement ratio was 1.37 for volume concentration of 0.05% Vol at low heat flux. Finally, this type of hybrid nanofluids could remove high heat flux at a small temperature difference, especially with this type of heater geometry, initial surface roughness, nanoparticles type, size, and the volumetric concentration.

【 授权许可】

Unknown