Metals | |
New Ti–35Nb–7Zr–5Ta Alloy Manufacturing by Electron Beam Melting for Medical Application Followed by High Current Pulsed Electron Beam Treatment | |
Cosmin Mihai Cotrut1  Andrey Koptyug2  Anton Teresov3  Yurii Ivanov3  Nikolay Koval3  Natalia Glukhova4  Maria Surmeneva4  Roman Surmenev4  Dmitriy Khrapov4  Alina Vladescu4  Anastasia Volkova4  Irina Grubova4  Alexander Tyurin5  | |
[1] Faculty of Materials and Science Engineering, University Politehnica of Bucharest, 313, Spl. Independentei, 060042 Bucharest, Romania;Faculty of Science, Technology and Media, Department of Quality Management and Mechanical Engineering, Mid Sweden University, Akademigatan 1, SE-831 25 Östersund, Sweden;Institute of High-Current Electronics, Siberian Branch, Russian Academy of Sciences, 634055 Tomsk, Russia;Physical Materials Science and Composite Materials Centre, Research School of Chemistry & Applied Biomedical Sciences, National Research Tomsk Polytechnic University, 30 Lenina Avenue, 634050 Tomsk, Russia;Research Institute for Nanotechnologies and Nanomaterials, G.R. Derzhavin Tambov State University, 392000 Tambov, Russia; | |
关键词: titanium alloy; Young’s modulus; additive manufacturing; electron beam melting; | |
DOI : 10.3390/met11071066 | |
来源: DOAJ |
【 摘 要 】
High-current pulsed electron-beam (PEB) treatment was applied as a surface finishing procedure for Ti–35Nb–7Zr–5Ta (TNZT) alloy produced by electron beam melting (EBM). According to the XRD results the TNZT alloy samples before and after the PEB treatment have shown mainly the single body-centered cubic (bcc) β-phase microstructures. The crystallite size, dislocation density, and microstrain remain unchanged after the PEB treatment. The investigation of the texture coefficient at the different grazing angle revealed the evolution of the crystallite orientations at the re-melted zone formed at the top of the bulk samples after the PEB treatment. The top-view SEM micrographs of the TNZT samples treated by PEB exhibited the bcc β-phase grains with an average size of ~85 μm. TEM analysis of as-manufactured TNZT alloy revealed the presence of the equiaxed β-grains with the fine dispersion of nanocrystalline α and NbTi4 phases together with β-Ti twins. Meanwhile, the β phase regions free of α phase precipitation are observed in the microstructure after the PEB irradiation. Nanoindentation tests revealed that the surface mechanical properties of the melted zone were slightly improved. However, the elastic modulus and microhardness in the heat-affected zone and the deeper regions of the sample were not changed after the treatment. Moreover, the TNZT alloy in the bulk region manufactured by EBM displayed no significant change in the corrosion resistance after the PEB treatment. Hence, it can be concluded that the PEB irradiation is a viable approach to improve the surface topography of EBM-manufactured TNZT alloy, while the most important mechanical parameters remain unchanged.
【 授权许可】
Unknown