Cross-Calibration of GF-1/WFV over a Desert Site Using Landsat-8/OLI Imagery and ZY-3/TLC Data

Remote Sensing

Wenbo Lv¹  Bo Zhong²  Qinhuo Liu²  Shanlong Wu²  Aixia Yang² 

[1] Beijing Geoway Times Software Technology Co., Ltd., Beijing 100043, China;State Key Laboratory of Remote Sensing Science, Institute of Remote Sensing and Digital Earth, Chinese Academy of Sciences, Beijing 100101, China;

关键词: cross-calibration;    GF-1/WFV;    HJ-1/CCD;    Landsat-8/OLI;    ZY-3/TLC;    BRDF;    TOA reflectance;   

DOI  :  10.3390/rs70810763

来源: DOAJ

【 摘 要 】

The wide field of view (WFV) is an optical imaging sensor on-board the Gao Fen 1 (GF-1). The WFV lacks an on-board calibrator, so on-orbit radiometric calibration is required. Zhong et al. proposed a method for cross-calibrating the charge-coupled device on-board the Chinese Huan Jing 1 (HJ-1/CCD) that can be applied to the GF-1/WFV. However, the accuracy is limited because of the wider radiometric dynamic range and the higher spatial resolution of the GF-1/WFV. Therefore, Landsat-8 Operational Land Imager (OLI) imagery with a radiometric resolution similar to that of the GF-1/WFV and DEM extracted from ZY-3 three-line array panchromatic camera (TLC) with a higher spatial resolution were used. A calibration site with uniform surface material and a natural topographic variation was selected, and a model of this site’s bidirectional reflectance distribution function (BRDF) was developed. The model has excellent agreement with the real situation, as shown by the comparison of the simulations to the actual OLI surface reflectance. Then, the model was used to calibrate the WFV. Compared with the TOA reflectance from synchronized Landsat-8/OLI images, all errors calculated with the calibration coefficients retrieved in this paper are less than 5%, much less than the errors calculated with the calibration coefficients given by the China Centre for Resource Satellite Data and Application (CRESDA).

【 授权许可】

Unknown