Analysis of the Mixing of Filler and Base Materials in Arc-Welded Single-Bead Surface Welds Using an EDXS Method

Materials

Aleš Nagode¹  Matija Zorc¹  Borut Zorc¹ 

[1]Faculty of Natural Sciences and Engineering, University of Ljubljana, Aškerčeva 12, 1000 Ljubljana, Slovenia

关键词: covered electrodes;    single-bead surface weld;    segregation;    EDXS analysis;    admixing rate;   

DOI  :  10.3390/ma15010217

来源: DOAJ

【 摘 要 】

This article deals with an analysis of mixing and determines the admixing rate of a base S355 steel plate in single-bead surface welds by measuring the chemical composition using a plane-scan energy dispersive X-ray spectroscopy (EDXS) on metallographic cross-sections. The results show that obtaining a larger number of EDXS measurements does not necessarily lead to obtaining a more accurate admixing rate. Due to the ever-present segregations that are generally near the base material, the disadvantage of this method is the subjective influence of the SEM operator on the estimated admixing rate. To obtain relevant results, a sufficiently wide area of well-mixed melt, including segregations, must be analyzed. This study showed that by using a sufficiently large number of appropriately selected sites with a sufficiently large surface area, it is possible to estimate the admixing rate from the chemical composition with an accuracy of ≥96% for the geometrically determined admixing rate D = 30%. From several equations, the best result showed an equation which is the arithmetic mean of the two different arithmetic means and in which the artificial influencing factor of the segregations of the base material is taken into account. With this equation, the same value of admixing rate, D = 30%, was obtained using the comparative geometric method.

【 授权许可】

Unknown