The Influence of Post-Weld Heat Treatment on the Microstructure and Fatigue Properties of Sc-Modified AA2519 Friction Stir-Welded Joint

Materials

Lucjan Śnieżek¹  Robert Kosturek¹  Janusz Torzewski¹  Marcin Wachowski¹ 

[1] Faculty of Mechanical Engineering, Military University of Technology, 2 gen. W. Urbanowicza str., 00-908 Warsaw, Poland;

关键词: friction stir welding;    heat treatment;    AA2519;    microstructure;    fatigue;    fractography;   

DOI  :  10.3390/ma12040583

来源: DOAJ

【 摘 要 】

The aim of this research was to investigate the influence of post-weld heat treatment (PWHT, precipitation hardening) on the microstructure and fatigue properties of an AA2519 joint obtained in a friction stir-welding process. The welding process was performed with three sets of parameters. One part of the obtained joints was investigated in the as-welded state and the second part of joints was subjected to the post-weld heat treatment (precipitation hardening) and then investigated. In order to establish the influence of the heat treatment on the microstructure of obtained joints both light and scanning electron microscopy observations were performed. Additionally, microhardness analysis for each sample was carried out. Fatigue properties of the samples in the as-welded state and the samples after post-weld heat treatment were established in a low-cycle fatigue test with constant true strain amplitude equal to ε = 0.25% and cycle asymmetry coefficient R = 0.1. Hysteresis loops together with changes of stress and plastic strain versus number of cycles are presented in this paper. The fatigue fracture in tested samples was analyzed with the use of scanning electron microscope. Our results show that post-weld heat treatment of AA2519 friction stir-welded joints significantly decreases their fatigue life.

【 授权许可】

Unknown