Cross-Sectional Analysis of the Resistance of RC Members Subjected to Bending with/without Axial Force

Materials

Marek Lechman¹ 

[1] Instytut Techniki Budowlanej, ul. Filtrowa 1, 00-611 Warszawa, Poland;

关键词: resistance;    bending;    axial force;    reinforced concrete;    composite;    section models;   

DOI  :  10.3390/ma15051957

来源: DOAJ

【 摘 要 】

This paper deals with the cross-sectional analysis of the resistance of RC members subjected to a bending moment with or without axial forces. To determine section resistance, the nonlinear material law for concrete in compression is assumed according to Eurocode 2, taking into account the effect of concrete softening. It adequately describes the concrete behavior of RC members up to failure. The idealized stress–strain relation for the reinforcing steel is assumed. For the ring cross-section subjected to bending with axial force and for areas weakened by an opening, normalized resistances have been derived by integrating corresponding equilibrium equations. They are presented in the form of interaction curves and compared with the results of testing conducted on RC eccentrically loaded columns. Furthermore, the ultimate normalized bending moment has been derived for the RC rectangle subjected to bending without axial force. It was applied to the cross-sectional analysis of steel and concrete composite beams consisting of the RC rectangular core located inside a reversed TT-welded profile. Comparative analysis indicated good agreements between the proposed section models and experimental data. The objective of the paper is the dimensioning optimization of the considered cross-sections with the fulfillment of structural safety requirements.

【 授权许可】

Unknown