EXPERIMENTAL INVESTIGATION TO STUDY THE VISCOSITY AND DISPERSION OF CONDUCTIVE AND NON-CONDUCTIVE NANOPOWDERS’ BLENDED DIELECTRICS

Advances in Sciences and Technology

G. Swami Naidu¹  C.L.V.R.S.V. Prasad²  K. Santarao² 

[1] Department of Metallurgical Engineering, JNTUK – UCEV, Vizianagaram, India;GMR Institute of Technology, Department of Mechanical Engineering, Rajam, India;

关键词: nanofluid;    viscosity;    dispersion;    sonication;    silicon carbide nano powder;    boric acid nano powder;   

DOI  :  10.12913/22998624/68463

来源: DOAJ

【 摘 要 】

Nano fluids are nanotechnology-based colloidal dispersions engineered by stably suspending nanoparticles. The characteristics of nano fluids such as thermal and electrical conductivities, viscosity, specific heat, dispersion etc. were studied and analyzed by earlier researches at different particle concentrations with different nano fluids. It was established that nano fluids have a significant impact on the process due the improvised characteristics. nano fluid viscosity and dispersion deserve the same attention as thermal conductivity in cases of nano dielectric fluids that are used in EDM as they influence the MRR. In this work, The viscosity and dispersion of the conductive and nonconductive nano powders blended dielectrics are investigated as a function of volume fraction so as to evaluate the behavior of these nano fluids at different particle volume concentrations. Kerosene and deionized water based nano fluids blended with conductive (SiC) and non-conductive (boric acid) nano particles are selected for the current study. It is observed that as the percentage volume fraction of Nano particles (both SiC and boric acid) increased, the viscosity was found increasing when blended with DI water. But the viscosity behavior with Kerosene blended with SiC and boric acid is not same. The existing experimental results about the nano fluids viscosity shows clearly that viscosity have a specific trend in variation with an increase of volume concentration. Boric acid blended with DIW and Kerosene shows similar trend in dispersion. However, in case of SiC blended with DIW and Kerosene showed some contradictory results giving scope for further investigation. The outcome of these experimental investigations will augment the works that are going on in studying its influence on MRR in EDM processes using nano blended dielectric medium.

【 授权许可】

Unknown