Microstructure and Wear Behavior of in Situ ZA27/TiB2 Composites

Metals

Zhiqiang Cao¹  Fei Chen²  Binbin Wang² 

[1] Key Laboratory of Solidification Control and Digital Preparation Technology (Liaoning Province), School of Materials Science and Engineering, Dalian University of Technology, Dalian 116024, China;School of Materials Science and Engineering, Jiangsu University, Zhenjiang 212013, China;

关键词: sliding wear;    microstructure;    hardness;    zinc;    TiB₂;    wear resistance;   

DOI  :  10.3390/met10121663

来源: DOAJ

【 摘 要 】

In situ ZA27/TiB₂ composites were synthesized successfully by diluting the in situ Al/TiB₂ composite, which was used as a master alloy. The microstructure and hardness of the developed in situ composites have been investigated. Results have shown that TiB₂ particles distribute uniformly through the matrix and significantly refine the matrix grain. The hardness of the composites was higher than that of the matrix alloy and increased with the increasing TiB₂ content. The dry sliding wear behavior under heavy loads and high rotation speed were studied in detail by using a pin-on-disc wear tester at room temperature. The results revealed that the wear resistance of the composites increased monotonically with the increase in the TiB₂ content. The composites had a lower coefficient of friction, friction temperature, wear rate, and specific wear rate especially under high loads when compared with the matrix alloy. An increase in the applied load increased the wear severity by changing the wear mechanism from abrasion and oxidation to adhesive wear. The composites possess better adhesive wear resistance properties compared with the matrix, which shows obvious adhesive wear as the load increased to 36 N, while the ZA27/3.0% TiB₂ composite did not show adhesive wear until the load increased to 54 N.

【 授权许可】

Unknown