Digital Approach to Rotational Speed Measurement Using an Electrostatic Sensor

Sensors

Lin Li¹  Kaihao Tang¹  Hongli Hu¹  Yong Qin² 

[1] State Key Laboratory of Power Equipment and Electrical Insulation, Xi’an Jiaotong University, Xi’an 710049, China;State Key Laboratory of Rail Traffic Control and Safety, Beijing Jiaotong University, Beijing 100044, China;

关键词: electrostatic sensor;    digital approach;    rotational speed;    correlation algorithm;   

DOI  :  10.3390/s19112540

来源: DOAJ

【 摘 要 】

In industrial production processes, rotational speed is a key parameter for equipment condition monitoring and fault diagnosis. To achieve rotational speed measurement of rotational equipment under a condition of high temperature and heavy dust, this article proposes a digital approach using an electrostatic sensor. The proposed method utilizes a strip of a predetermined material stuck on the rotational shaft which will accumulate a charge because of the relative motion with the air. Then an electrostatic sensor mounted near the strip is employed to obtain the fluctuating signal related to the rotation of the charged strip. Via a signal conversion circuit, a square wave, the frequency of which equals that of the rotation shaft can be obtained. Having the square wave, the M/T method and T method are adopted to work out the rotational speed. Experiments were conducted on a laboratory-scale test rig to compare the proposed method with the auto-correlation method. The largest relative errors of the auto-correlation method with the sampling rate of 2 ksps, 5 ksps are 3.2% and 1.3%, respectively. The relative errors using digital approaches are both within ±4‰. The linearity of the digital approach combined with the M/T method or T method is also superior to that of the auto-correlation method. The performance of the standard deviations and response speed was also compared and analyzed to show the priority of the digital approach.

【 授权许可】

Unknown