期刊论文详细信息
Sustainability 卷:12
On the Performance of Small-Scale Horizontal Axis Tidal Current Turbines. Part 1: One Single Turbine
Roozbeh Alipour1  Ramin Alipour1  Seyed Alireza Ghazanfari2  Michal Petrů3  Seyed SaeidRahimian Koloor3 
[1] Department of Mechanical Engineering, Mahshahr Branch, Islamic Azad University, Mahshahr, Iran;
[2] High-Speed Reacting Flow Laboratory, Faculty of Mechanical Engineering, Universiti Teknologi Malaysia, UTM Skudai 81310, Johor, Malaysia;
[3] Institute for Nanomaterials, Advanced Technologies and Innovation, Technical University of Liberec, Studentska 2, 461 17 Liberec, Czech Republic;
关键词: tidal energy;    horizontal axis tidal current turbine;    TSR;    power coefficient;    CFD analysis;   
DOI  :  10.3390/su12155985
来源: DOAJ
【 摘 要 】

The blade number of a current tidal turbine is one of the essential parameters to increase the stability, performance and efficiency for converting tidal current energy into rotational energy to generate electricity. This research attempts to investigate the effect of blade number on the performance of a small-scale horizontal tidal current turbine in the case of torque, thrust coefficient and power coefficient. Towards this end and according to the blade element momentum theory, three different turbines, i.e., two, three and four-bladed, were modeled using Solidworks software based on S-814 airfoil and then exported to the ANSYS-FLUENT for computational flow dynamics (CFD) analysis. SST-K-ω turbulence model was used to predict the turbulence behavior and several simulations were conducted at 2 ≤ tip speed ratio ≤ 7. Pressure contours, turbulence kinetic energy contours, cut-in-speed-curves, and streamlines around the blades and rotors were extracted and compared to provide an ability for a deep discussion on the turbine performance. The results show that in the case of obtainable power, the optimal value of tip speed ratio is around 5, so that the maximum power was achieved for the four-bladed turbine. Out of optimal condition, higher blade number and lower blade number turbines should be used at less than and greater than the optimal values of tip speed ratio, respectively. The results of simulations for the three-bladed turbine were validated against the experimental data with good agreement.

【 授权许可】

Unknown   

  文献评价指标  
  下载次数:0次 浏览次数:0次