Influence of anchorage length and pretension on the working resistance of rock bolt based on its tensile characteristics

International Journal of Coal Science & Technology

Kai He¹  Dong Li¹  Jucai Chang¹  Chuanming Li¹  Dongdong Pang¹  Bingjun Sun¹ 

[1] Key Laboratory of Safe and Effective Coal Mining of the Ministry of Education, Anhui University of Science and Technology, 232001, Huainan, China;

关键词: Working resistance of rock bolt;    Pretension;    Anchorage length;    Ordinary bolt;    High-strength bolt;    Quadrilateral section roadway;   

DOI  :  10.1007/s40789-021-00459-9

来源: Springer

【 摘 要 】

In coal mining roadway support design, the working resistance of the rock bolt is the key factor affecting its maximum support load. Effective improvement of the working resistance is of great significance to roadway support. Based on the rock bolt’s tensile characteristics and the mining roadway surrounding rock deformation, a mechanical model for calculating the working resistance of the rock bolt was established and solved. Taking the mining roadway of the 17102 (3) working face at the Panji No. 3 Coal Mine of China as a research site, with a quadrilateral section roadway, the influence of pretension and anchorage length on the working resistance of high-strength and ordinary rock bolts in the middle and corner of the roadway is studied. The results show that when the bolt is in the elastic stage, increasing the pretension and anchorage length can effectively improve the working resistance. When the bolt is in the yield and strain-strengthening stages, increasing the pretension and anchorage length cannot effectively improve the working resistance. The influence of pretension and anchorage length on the ordinary and high-strength bolts is similar. The ordinary bolt’s working resistance is approximately 25 kN less than that of the high-strength bolt. When pretension and anchorage length are considered separately, the best pretensions of the high-strength bolt in the middle of the roadway side and the roadway corner are 41.55 and 104.26 kN, respectively, and the best anchorage lengths are 1.54 and 2.12 m, respectively. The best anchorage length of the ordinary bolt is the same as that of the high-strength bolt, and the best pretension for the ordinary bolt in the middle of the roadway side and at the roadway corner is 33.51 and 85.12 kN, respectively. The research results can provide a theoretical basis for supporting the design of quadrilateral mining roadways.

【 授权许可】

CC BY