Effect of Thermal Cyclic Loading on Stress-Strain Response and Fatigue Life of 3D Chip Stacking Structure

Chinese Journal of Mechanical Engineering

Sujuan Zhong¹  Weimin Long¹  Liang Zhang² 

[1] Zhengzhou Research Institute of Mechanical Engineering Co., LTD, 450001, Zhengzhou, China;Zhengzhou Research Institute of Mechanical Engineering Co., LTD, 450001, Zhengzhou, China;School of Mechatronic Engineering, Jiangsu Normal University, 221116, Xuzhou, China;

关键词: 3D-IC;    Taguchi method;    Control factors;    Fatigue life;   

DOI  :  10.1186/s10033-021-00640-w

来源: Springer

【 摘 要 】

The thermo-mechanical reliability of IMCs (Ni3Sn4, Cu3Sn, Cu6Sn5) solder joints and Sn-3.9Ag-0.6Cu solder joints was investigated systematically in 3D chip stacking structure subjected to an accelerated thermal cyclic loading based on finite element simulation and Taguchi method. Effects of different control factors, including high temperature, low temperature, dwell time of thermal cyclic loading, and different IMCs on the stress-strain response and fatigue life of solder joints were calculated respectively. The results indicate that maximum stress-strain can be found in the second solder joint on the diagonal of IMC solder joints array; for Sn-3.9Ag-0.6Cu solder joints array, the corner solder joints show the obvious maximum stress-strain, these areas are the crack propagated locations. The stress-strain and fatigue life of solder joints is more sensitive to dwell temperature, especially to high temperature; increasing the high temperature, dwell time, or decreasing the low temperature, can reduce the stress-strain and enlarge the fatigue life of solder joints. Finally, the optimal design in the 3D-IC structure has the combination of the Cu6Sn5/Cu3Sn, 373 K high temperature, 233 K low temperature, and 10 min dwell time. The fatigue lives of Sn-3.9Ag-0.6Cu under 218–398 K loading in the 3D assembly based on the creep strain are 347.4 cycles, which is in good agreement with experimental results (380 cycles).

【 授权许可】

CC BY