The Influence of Forefoot Bending Stiffness of Futsal Shoes on Multiple V-Cut Run Performance

Frontiers in Psychology

article

Shariman Ismadi Ismail¹  Hiroyuki Nunome³  Yuji Tamura³ 

[1] Faculty of Sports Science and Recreation, Universiti Teknologi MARA;Graduate School of Sports and Health Science, Fukuoka University;Faculty of Sports and Health Science, Fukuoka University

关键词: futsal shoe;    bending stiffness;    sole hardness;    running;    change of direction;   

DOI  :  10.3389/fpsyg.2021.625079

学科分类：社会科学、人文和艺术（综合）

来源: Frontiers

【 摘 要 】

A forefoot bending stiffness (FBS) property of footwear is known to benefit athletes in running performance. To date, the efficacy of bending stiffness on performance is rather unknown from the perspective of futsal shoes. This study investigates the influence of bending stiffness property of three commercial futsal shoes on change of direction run resultant performance. Nineteen university level athletes participated in the human performance test (multiple V-cut change of direction run) on a hardwood flooring facility using three pairs of futsal shoes (i.e., S1, S2, and S3) with different models but similar in outsole material (S1—mass: 311 g, heel-to-toe drop: 10 mm, friction coefficient, 1.25; S2—mass: 232 g, heel-to-toe drop: 8 mm, friction coefficient: 1.34; and S3—mass: 276 g, heel-to-toe drop: 7 mm, friction coefficient: 1.30). The FBS properties for each shoe were mechanically measured. Results from the analysis of variance indicated that there was a significant difference of FBS value among the three shoes (S1: 0.32 Nm/deg., S2: 0.26 Nm/deg., and S3: 0.36 Nm/deg.) [ F (2,8) = 28.50 ( p < 0.001)]. Shoes with relatively higher shoe-playing surface friction coefficient (S2 and S3) had significant impact on the V-cut performance ( p < 0.05) when compared with the shoe with lower friction coefficient (S1). In contrast to the literature, the shoe with the lowest FBS (S2) did not suffer any detriments on the resultant performance in the test conducted. These findings suggested that there could be other performance limiting factors, such as the friction coefficient, rather than FBS that have greater influence on the test outcomes.

【 授权许可】

CC BY